Condensation

[mbstookal]

If I want to swap my 3/16" gas line for a 1/4" gas line from C02 cylinder into kegerator, I will have to make a larger entry hole into the kegerator. Will I need to silicone seal the new larger hole to prevent outside air from getting into kegerator? Will duct taping the new larger hole be sufficient? I don’t want a condensation issue in the kegerator.

[coolman26]

I would use a touch of silicone to seal.

[santoch]

@mbstookal

If I want to swap my 3/16" gas line for a 1/4" gas line from C02 cylinder into kegerator, I will have to make a larger entry hole into the kegerator. Will I need to silicone seal the new larger hole to prevent outside air from getting into kegerator? Will duct taping the new larger hole be sufficient? I don’t want a condensation issue in the kegerator.

Are you moving the tap further away so you need a longer run?  Be careful or you will get lots of foam.

[skatz (Stevie)]

@santoch

@mbstookal

If I want to swap my 3/16" gas line for a 1/4" gas line from C02 cylinder into kegerator, I will have to make a larger entry hole into the kegerator. Will I need to silicone seal the new larger hole to prevent outside air from getting into kegerator? Will duct taping the new larger hole be sufficient? I don’t want a condensation issue in the kegerator.

Are you moving the tap further away so you need a longer run?  Be careful or you will get lots of foam.

Gas line, not liquid.

[santoch]

DOH!  I should have looked closer.