I get impatient even when lager-ing. A lot of writing recommends stepping down the temperature gradually, say two degrees or so every twelve hours. I go more like five.
The point, as I understand it, is to not shock the yeast to death.
Do the same rules apply for cold-crashing before packaging? I’m going to bottle an APA on Sunday. In the past (given the word “crash”) I just set the controller to 34F and walk away. I’m wondering: is there a better way to do it?
Seems like the idea of not shocking the yeast would apply here too, though I guess yeast health is more important in lager-ing than in bottling.
I cold crash both ales and lagers. I just wait til after fermentation is finished so there’s no danger of “yeast shock”. I do exactly what you say you’ve done…set the fermentation chamber to 33F, put the fermenter in, and leave it.
Exactly what I do too. No bother with dropping temps slowly. Same for both ales and lagers providing no diacetyl or other fermentation off-products are noticeable.
I’ve heard that rapid chilling can stress the yeast and cause them to exude flavor compounds that may be undesirable in the beer. I’m not convinced that these compounds are produced or are tasted, but it is a curious phenomena.
I suggest that someone perform an exbeeriment to see if there is a perceivable difference.
Same here. I think the people who report off flavors/aromas from crashing may be pushing the envelope timewise with their crashing. I don’t crash ales until I’m at least a couple days past verified FG, lagers also get an extended d-rest before crashing. So by the time I crash, the yeast have basically done their job, cleaned up their mess, and hit the time clock. No off flavors/aromas for me.
Edit - I don’t doubt that there could be some strains more prone to causing issues when quick crashed. Just none of the ones I’ve used were.
Great info all! If this APA weren’t so in-demand, (my coworkers are really champing at the bit for this batch) I would split it up and experiment. Next batch perhaps.
The way to prevent/eliminate impatience is to brew so many batches in quick succession that you actually get sick and tired of having another fermenter to clean, another hose to clean, another keg to clean. It may take a lot, but once you get there, you’ll be able to wait out a batch without blinking an eye.
According to a blip knowledge drop by Zainasheff you have to drop faster than 2F per hour to experience a problem. Good luck doing that with more than a couple gallons. I crash by setting my controller to 30F and walking away. Never a problem
Agreed. Until you get to the point where you start waiting on kegs to blow, so you can open up a fermenter for another brew session…then the dilemma becomes how many kegs can you justify having? I’m at 17 and SWAMBO says that’s enough!