Looking for info tips tricks on everything and anything you about them, best set up (only doing one tap for now), coil vs cold plate, length of coil, length of line to jocky box, best place to buy parts to build one, like I said all info is helpful thanks guys.
Not a traditional jockey box, but some good ideas for an easy build on a different forum thread at:
http://forum.northernbrewer.com/viewtopic.php?f=3&t=77879
Mine from that thread as shown on the last page, I use quite a bit and it works great.
The caulk/adhesive I used to seal the cut hole into my cooler has remained 100% rock solid adhered and waterproof.
Just some ideas…
This is a write-up of our club’s jockey box build from a bunch of years ago. It uses a 4-circuit cold plate.
http://home.comcast.net/~midnighthomebrewers/jockey_box.htm
Since this write-up, we have replaced the cooler. This time we ran all of the beer supply lines out through one side of the box instead of the rear, as it is more convenient to hook the kegs up that way while the box is sitting on a table.
Alright so the wife surprised me and looks like we are buying a pre built one from AIH anyone have tips or advice when using it at an indoor event.
- test it out at home in advance of the event… it will save you time and major disaster of something going wrong when setting up for the event.
- they are notorious for lots of foamy pours, try to get the pressure right on your tank, around 15-18 psi should help keep the foam down if still foamy increase pressure slowly.
- hook up all the beer etc… and put the ice in LAST! also only put in enough ice to chill the beer you don’t want a ton of ice sitting on the coils and the beer resting in the coils or plate and getting “super chilled” which will cause even more foam and maybe even freeze the line.
- clean it immediately after using it using beer line cleaner and sanitizer… otherwise you’re looking at a germ fest!
have fun!
I have a plate chiller one, so maybe not completely analogous, but I have to get the pressure up between 18 and 20 psi to get a good pour. It also helps a ton if the beer you are pouring is already cold, and try to keep it from getting too warm throughout the event. At the very least keep it in the shade, but ideally a small bucket with some ice in it will help on a hot day. I’ve heard the coiled jockey boxes are more efficient at transferring the heat, so maybe it won’t matter for you.
Sweet was planing on doing a few pours at home to get it set figured I will take a 5 gal bucket se the keg in it and ice it at the event to help.
Do you want an even amount of ice to water in the cooler or is more Ice less water better?
Came yesterday and got the keg sparkling and sanitized loaded it up with beer chilled in the freezer ( was cold crashing for 6 days so helped). Force carbed sitting in a swamp cooler now till the event
Have fun with it
+1
Poured for the first time yesterday had a few foaming hick ups but once we got it set was pretty good
And brought home 1st place in people’s choice