well started building my rig today. Using work to build it as I am not a welder nor do I have the money to buy my own. Im currently going with a gravity system with plans in the future for a pump or two to make moving water to the HLT easier than manual labor. How do you go about cleaning the pumps is my one question is it the same as just running PBW through the lines to clear them or is there more to it? Ill post pics later.
Not a bad idea to take the impeller cover off once in a while to check for any small amount of debris that may have gotten stuck in there.
Normal cleaning: recirculating PBW, rinse with water.
Nice cart…you should look up “hurricane stove” for a mid priced stove that will not hot spot your kettle…then you should get a nice 10 gallon kettle…That 8 gallon low end kettle is not really big enough for 5.5 gallon bathes…I had the same stove kettle setup…sold the stove…use the kettle a bit still…never on the stove though…welcome to the hobby…
Awesome I am in need of a new stove now anyway as it is literally falling apart at the burner. I do want to get a bigger kettle I noticed on my first batch that it was short by 1/2 a gal.
