I am in the process of building a new Mash/Lauter Tun and am wondering what everyone uses for a false bottom as far as hole size? The way I built this I can’t use a manifold or SS braid and am planning on using perforated SS plate with the outlet under that. I found a piece of perf plate with 1/8" holes and used it once with a lot of issues as far as getting grain husks in my Wort. I have since located a piece with 1/16" holes and am planning on giving that a try but am a little concerned that I may have problems with the holes pluggin up. I know I could order one online with 3/32" holes but I would have to cut it down to fit (as well as spending more $). Has anyone used 1/16" holes and if so were there any problems with plugging?