Good evening everyone. I’m new to the forum
After a few years of brewing I have the need to switch from direct fire to electric. I have a very (probably stupid) question. Before drilling a 1,5" hole in my SS Brewtech 15Gal kettle I would like to know if there is and kind of removable heating element options on the market. Something like a submergible element that hooks up to the top of the kettle without the need of drilling. I was also thinking about a RIMS system but I don’t think you can get to boiling with rims and also not sure the pump will work with boiling water.
Many thanks
It has ultra-low watt density so it won’t scorch your wort or get nasty brown burnt stuff all over it. It requires two small holes to be drilled in the kettle but it comes with a template for drilling them and there is some tolerance for error in the placement.
Have you considered an Induction Burner? I use one for my strike water kettle and it’s awesome! I was unable to find mine on Amazon, so I found it on a restaurant supply site. No drilling required. You will need to make sure the bottom of your kettle is magnetic.
Looking into induction recently.
Which one do you have ?
Which one would you get knowing what you know now, and cost not being a factor ?
I have several 220 outlets in garage.
I bought the burner below Apr 2018. I wanted this one because it has a metal frame to help support the weight of the kettle and water/wort. I wanted 3500 for the speed. I heat to strike and then again to boil at 3500 then reduce it to 1600 to maintain the boil. It has worked flawlessly and I would buy it again.
BrewBama, that looks awesome. I would do something like that if I had an electrical system that would allow it. Unfortunately, I am stuck with only 110 unless I want to do a lot of electrical work.
We bought our home about 25 years ago, the previous owner was a tool and die maker.
The garage and basement was set up as a machine shop.
Many 220 outlets in garage and basement, with different types of 220 outlets.
