I have been using 15 gallon plastic induction tanks for about a year now with great success. The only modification I have made to them is using LD Carlson’s Better Bottle Racking Adapter installed just as you would in a better bottle carboy. I have not had a problem at all with this system as the racking adapter is easily removed for easy cleaning. The only downside to these induction tanks is that they are not able to be pressurized, but on the small scale it is not that big of a hassle. However, I am currently putting together all of the equipment needed for my 3 bbl brewery.
Due to the low cost of these tanks, along with the approval from the Washington State Dept. of Ag, I have been thinking about using them. Here’s where I run into problems. I’m fairly positive that I can get these to seal where they could hold up to 20 psi. The problem lies in the holes that I’m going to have to port into a tank. One for the racking arm, one for the thermowell, two for the immersion chiller, one for the co2 port, and one more for the cip. That’s six hole that are going to have to be drilled with at least two of them below the liquid line. Times six fermenters, thats 36 holes I have to worry about sealing, not to mention the 12" lid.
I have found some very nice SS pieces that are very sanitary that would work great, but I’m just worried that some time during the course of using any one of the tanks that I might run into problems with and I really dont want to have that happen with 100 gallons of beer sitting in it. Anyone have any advice for me? I really dont want to have to spend $1900 a pop for SS fermenters if I don’t have to right away.
Like it or not.
You can not seal the fermenter.
I have tried but had to buy bright tanks.
You should use bulkhead fittings for your ports.
Something like this: 1" Polypropylene Bulkhead Tank Fitting with EPDM Gasket - 2-1/4" Hole Size | U.S. Plastic Corp..
Plumb your racking port with 1 1/2" TC fitting.
You can use 1" for CIP
and 1/2" for cooling coil.
Your cooling coil HAS to be SS.
Tape the temp probe to the wall and insulate your fermenter.
No need for thermowell.
No need for CO2 port.
I looked at those and I was wondering if they are threaded on the inside of the bulkhead fitting otherwise how are you going to connect your racking arm to it.
ok that makes sense so the ID of the bulkhead is threaded. if your nipples are independent of each other how do you adjust your racking arm? I’m about to head down to my local industrial hardware store and take a look at some. I was thinking if i did a 2" bulkhead fitting with a 1 1/2" racking arm that is threaded in from the outside that would give me adjustability and the ability to remove for easy cleaning.
Racking arm is fixed and above the bottom of the conical maybe a couple inches. Notice it’s centered right over the dump port hole. I dump the yeast until beer runs, clear the yeast out of the racking port & fill kegs until I see yeast flowing again. All in all I lose maybe a quart of beer in the process. The yeast clings pretty good on the wall of the conical until you get down to the end.
Here’s a pic of the yeast in the conical after I racked off the beer.
I went down to my local irrigation specialists and too a look at their 2" bulkheads and totally agree that this would work. How well does the bulkhead fitting deal with the curvature of the tank? Where did you find food grade gaskets for them? Also was thinking about how you’d do your racking arm and was thinking custom build the arm and use a compression fitting to seal the arm in the fitting.