I’m wondering how to get that slow moving bitterness that creeps up on you and bites you on the back end? In most of my IPAs the bitterness is quite upfront, but I’d like to know how to get that bitterness to be a little more delayed?
A good 60 minute addition and get the sulfates up above 150 ppm. I am targeting 200 ppm SO4 for my bitter IPAs and PAs now. I used to use 350, that is too much for me now.
Agreed with the above. Also, mashing around 5.4 pH is said to enhance hop character. Having slightly elevated Mg content is also said to enhance bitterness per Brunwater. I keep mine no more than around 15ppm. More is definitely not better here.
Edit - Also, bittering with a hop like Columbus gives an IPA the assertive bitterness you’re looking for, whereas a hop like Magnum might give the same IBU number in software but taste much less assertive.
Thank you! I have recently only been doing 30min boils with 15min and less hop additions so will try 60mins with a solid American hop. My sulphate levels are always at around 300ppm for IPAs so I think I’m good there.
Have you tried adding a sprinkle of cal chloride to your beer (in the glass) and see if it helps delay the bite. You may just want to bump up your chloride a bit.
I use 45-50 ppm chloride and IMO I get a smooth biterness up front and bite in the back. My sulfate is also @ 300ppm.
curtdogg, my water profile is the same as yours. I don’t plan on changing it either. I personally like slightly more specialty malts in this style of beer to mellow out the high hop bitterness. I use honey malt, munich and biscuit, not all in the same recipe though.