When to add a fruit, before or after boil?

So I’m still pretty much a rookie Homebrewer. I’ve made 5 different batches, none have skunked and all have come out fairly well, but there’s still a lot of stuff I don’t know.

I’m assembling a recipe for a Cherry Rhubard wheat to brew this weekend, as I have some fresh organic cherries and rhubard from a local farm I want to throw into the mix. I’ve got all my hops and yeast and malt selections and everything, but the thing I can’t figure out is when to add the fruit. Do I let it steep at ~170F for a time, then remove the fruit and continue with the normal boil, or do I do the same thing but after the boil has completed and I’ve removed the hop bag? Some recipes even recommend adding fruit only as the beer goes into the fermenter.

What do people recommend here in this forum? I guess I’m not sure how the timing of adding the fruit affects the flavor profile. Will adding later make it stronger?

I made a pumpkin beer last fall and used 10lbs of Fresh pumpkin and let it steep pre-boil and it came out fantastic, so I’m tempted to do the same here, but with rhubarb and cherries being a tart flavor I’m questioning where it should be added to help be able to really taste the fruit flavor. I’ve got 5lbs of each to add to the beer.

Thoughts?

I would freeze the fruit. This will break apart the fruit cells and help release juice as it thaws. Then put the fruit in post boil so that volitile fruit flavors are not lost during boiling. The hot wort will sanitize the fruit and the juice that is released. Put the fruit in a bag for easy removal.

Be aware that fruit that goes through primary fermentation changes in flavor. Its good - hard to describe the change until you try it.  But if you want really fresh fruit flavor then the beer needs to be aged on fruit after fermentation. This is more of a pain. You’d have to santize the fruit by heating to 170 for 10 minutes, then rack the beer on top and let it age. Fermentation will kick up from the added sugars. Personally, this very fresh fruit flavor is not what I’m looking for in fruit beers. It tastes more like beer with juice added.

When I use fruit, I add it to the secondary, after primary fermentation is finished.

@MtnRockHopper that’s some great info & advice right there. I tend to like a really fresh fruit flavor in a fruity wheat, but you’ve given me a great idea for when I can put it in to really impart the flavor.

Thanks!!

Dont boil the fruit or you’ll set the pectins which will lead to really hazy beer.  I’ve always gone down the road of freezing the fruit, then adding it to the secondary.

If you keg then a hop bag full of frozen fruit such as raspberries submerged in the keg pre-carbonation is another way to go. If you drop the bag into a keg that is already carbonated be prepared to close the lid immediately as it will foam over in seconds.

When adding rhubarb be sure to extract the juice and add the juice to the secondary. Leaving the rhubarb stalks in the fermentor could cause unwanted, excessive bitterness in the beer.

I have always added it right at the end of the boil turned off the heat and let it set for 10 mins. I then chill the wort to pitching temp then pour it into the fermenter. I always use a plastic bucket when doing fruit beers it is much easier. Also use a blow off tube or you could have some major problems.

Lesson learned:

If you’re adding fruit to a fermentor (carboy)… PUREE FIRST.

I like to add fruit as a flavorant in the secondary… but it can be interesting as added fermentables in the primary. You could add a certain amount to reach your target OG (no more than 10-15% of total fermentables), then adjust for flavor in the secondary.

I think that rhubarb shouldnt have too much contact time with the beer to reduce bitterness extraction, as mentioned above.

Good luck! Please post your methods/results!